It is mainly used for automatic glass loading. After putting the glass in the designated position and giving the signal of loading, the big arm turns up about 95 degrees through the overturning mechanism, and the whole machine starts to move forward. When the induction device on the small
arm touches the glass, the whole machine stops walking and the glass is sucked by the suction cup through the vacuum system on the glass,small arm lifting motor lifts the glass upward and backward about 80 mm. The walking motor retreats and the big arm falls down. When the bing arm is in place, the suction cup under the glass begins to blow. When the small arm falls down, the glass falls on the conveyor wheel. Finally, the glass is conveyed to the cutting table by the conveyor wheel.
Technical parameter:
* ,Sheet size: Min size: 2400 *1500mm (Single Side loading)
* ,Max loading size: 6100 x 3300 mm
* ,Glass sheet thickness: 3 ~ 19mm
* ,Working absorption depth: 700 mm
* ,X-axis walking speed: 5-25m/min (adjustable)
* ,Y-axis walking speed: 8-12 m/min (adjustable)
* ,Conveying speed: 5-25m/min (adjustable)
2.CY-CNC-6133(G type)Fully automatic glass cutting machine
Its working principle is to convey the cut glass by conveying belt to worktable, automatically input the position of glass
through photoelectric scanning system, and then the cutting head with diamond wheel on the cutter holder moves along X and Y
directions respectively by program control,cutc the sheet. CNC motion controller is used in the control part of the machine, and
advanced AC servo motor is used in the drive part.
Technical parameter:
* ,Max size:6100×3300mm
* ,Thickness:3～19mm
* ,Cutting accuracy:±30
* ,Cutting accuracy of special-shaped glass:±35
* ,Cutting speed:0-200m/min
* ,Conveying speed:0-25m/min
3.CY-BP-6133 Air-floated breaking table (3+1 type)
Technical parameter:
1),Breaking bar: 3+1 type----
2),Table Size: 6300×3500mm
3),Glass thickness:3-19mm
4),Power: 8kw
5),Table height: 900 + 20mm
Company Overview
